Rear / Bottom Panel Designations (Figure 2.0) - Laird LTM-CPDV User Manual

3
1
IEEE 1394 6-Pin Connector
This connector is used to connect to a compatible camera or NLE. POWER IS
NOT PROVIDED VIA THE 6PIN CABLE . THE CapDiv
EXTERNALLY AT ALL TIMES.
Power-Idle & Mode Switch (three positions)
2
This switch has three-positions. In the center position, power is turned off and the
CapDiv ™ is put in standby mode. Sliding the switch off center and toward the
"VTR" position turns the CapDiv
off center and towards the "HDD" position turns the CapDiv
HDD mode.
NOTE: When switching between HDD and VTR, allow two seconds at
the center position to permit idle reset. If the switch "pause"
operation is not done, the CapDiv
proper mode.
DC Power Connector
3
Power can be supplied to the CapDiv
to operate over a 10V to 24V DC range with the center post connected to the
positive terminal. DC Current draw is 1.5 Amps.
800-898-0759 • 845-339-9555 • 2000 Sterling Road • Mount Marion, NY 12456 • www.lairdtelemedia.com
LTM-CPDV
CapDiv
DV Disk Recorder
F 2.0 / B
IGURE
™ Portable
P F
OTTOM ANEL
2
™ on and initializes VTR mode. Sliding the switch
™ via this connector. The device is designed
- Page 5 -
UNCTIONS
™ MUST BE POWERED
™ on and in the AV
™ may not initialize in the
1