Power Options / Battery Pack Recharging - Laird LTM-CPDV User Manual

CapDiv ™ is able to draw power from several convenient sources.
These include:
■ CapDiv
™ must be powered at all times by a 12V DC source @ 1 Amp. It DOES NOT
draw power via the 6-Pin IEEE 1394 FireWire connector.
■ It may be powered with the enclosed, belt-worn 12V DC rechargeable battery.
■ It may be powered from the included 110-220V AC to 12V DC adapter.
Your CapDiv ™ includes a 12V portable battery power pack. Although this battery pack is
shipped with a charge, it is recommended that the battery be charged for six (6) hours before
its initial use.
USE: Simply plug the battery pack output cord into the power input of CapDiv
CHARGING:
WARNING: Never leave your battery in the charge mode for longer than 24
hours. Excessive charging can cause permanent damage to your bat-
tery and can cause leakage. If the installed AUTOMATIC FUSE should
blow out, return the unit for replacement.
The battery power pack should be charged after each use. To charge, simply connect the
battery pack to the charging station. The time required for a full charge depends on the
amount of power left in the battery (see guide below).
Charge Needed
STORAGE:
Battery should be stored with a full charge and be charged again every three months when
not in use. It should also be stored in a cool, dry place. This will help preserve the battery
and insure long life. Under no circumstances should the battery pack be punctured or disas-
sembled in any way. NEVER insert the battery plug into anything other than the charging
station or the CapDiv™.
800-898-0759 • 845-339-9555 • 2000 Sterling Road • Mount Marion, NY 12456 • www.lairdtelemedia.com
LTM-CPDV
CapDiv
DV Disk Recorder
C D
AP
C D ™ P
AP IV
25%
50%
100%
™ Portable
™
P O
IV OWER PTIONS
B
ORTABLE ATTERY
Charge Time
2 Hours
4 Hours
8 Hours
- Page 3 -
P
OWER
™ .