Haier HDC10SS User Manual page 8

English
Note: You can remove the carafe at any time during the brewing
cycle and pour a cup of coffee. The coffeemaker will automatically
stop dripping while the carafe is removed. To avoid a possible over
flow, replace the carafe with in 30 seconds.
7) Do not open the flip up lid cover during the brew cycle. The flow
back of hot water could damage the coffeemaker.
8) You can take remove the carafe and serve when the brewing cycle is
completed.
Note: The coffee produced will be slightly less than the water you
have poured in, as the coffee grounds absorb some water. For your
safety, you should keep the lid of carafe down when pouring. This
also helps to keep the coffee warm.
9) Always turn the coffee maker off and unplug the power cord from
the electrical outlet when the coffee maker is not in use.
Note: Always Use caution when pouring hot coffee, as the fresh
brewed coffee is very hot.
Automatic/Delayed Brew Function
Your coffee maker is fully programmable. You can set it to brew up to
24 hours in advance. (For example if the current time is 5:10 PM, you
can set the coffee maker to automatically start at 8:15PM)
First follow steps 1 through 5 of the above "making coffee" section.
Now you will need to set the automatic start function as follows:
1) Press the "ON/OFF" button twice; the "AUTO"
indicator should now be illuminated.
2) Press the "PROG" button; the "LCD" should now
be displaying "CLOCK". Set the clock to the cur-
rent time by pressing the "HOUR" and "MIN"
buttons. (Fig.2)
Note: The time cycle is 12 hours, ever 12 hours;
3) Press the "PROG" button; the "LCD" should now display "TIMER",
now set the automatic start time by pressing the "HOUR" and "MIN"
buttons. (fig.3) As per our example, at 8:15PM the "AUTO" indicator
light will go off, and the "RUN" indicator light will be illuminated.
The coffee maker will now start automatically. After brewing, you will
be ready to start serving.
Note: If you leave your coffee maker unattended for 2 hours, it will
7
the "AM" and "PM" will change. Please be
sure to set the clock to the correct current time "AM or "PM"
shut off automatically.