Table of Contents
Advertisement
2. Specifications
Capacity
Threading
Pipe...................................................1/8" to 2"
Bolt...................................................1/4" to 2"
Cutoff
Pipe...................................................1/8" to 2"
Bolt....................................................1/4" to 1"
Power Supply
Volt......................120v 50-60 Hz single phase AC
Motor....................................................1/2 HP
Weight (machine only)...............................80 lbs.
3. Function/Operation Description
3.1 Using BT-30033 pipe cutter
Swing die head and reamer away to out-of-way position.
Lower pipe cutter down to pipe.
Move carriage to adjust cutter wheel position to where the pipe will be cut.
Tighten the pipe cutter handle and make sure the two rollers and cutter wheel touch the pipe
Turn switch to "forward" position and step on the foot switch.
Keep turning the pipe cutter handle until pipe is cut off.
Release footswitch and switch it OFF position.
Return pipe cutter to out-of-way position.
3.2 Using BT-30032 reamer
Swing pipe cutter and die head to out-of-way position
Lower reamer (BT-30032) and align with pipe
Extend reamer by pushing Latch and sliding knob toward pipe until latch engages square bar
Switch to forward position and step on foot switch.
Moving carriage toward to pipe and complete reaming the pipe
Retract reamer bar ad return reamer to out-of-way position.
3
Advertisement
Table of Contents
