Stand Alone Keyboard - Metrologic MS9535 VoyagerBTSeries Installation And User Manual

C I
RADLE NSTALLATION TO THE

Stand Alone Keyboard

1. Turn off the host system.
2. Connect the 10-pin RJ45 male
connector into the 10-pin modular
jack on the bottom of the cradle.
3. Connect the 6-pin Mini-DIN male
connector of the keyboard cable to
keyboard port on the host device.
4. Plug the external power supply into
the power jack on the bottom of the
cradle.
Check the AC input
requirements of the power
supply to make sure the
voltage matches the AC
outlet. The outlet must be
located near the requirement
and be easily accessible.
5. Plug the power supply into the AC
outlet. The blue LED on the rear of
the cradle will stay on.
6. Turn on the host device.
7. Establish communication between the scanner and cradle.
See page 15 for complete instructions on Establishing Bluetooth
Communication between the scanner and cradle.
The scanner must be charged for a minimum of 3 hours before the
scanner can be placed in full operation for the first time. After the initial
preparation charge of 3 hrs, the battery will only require 2.5 hrs to come
to a full charge when it gives a Low Power warning (see page 18).
See page 6.
H D
OST EVICE
Figure 6. Stand Alone Keyboard
9