Table of Contents
Advertisement
Power Connector Pinout
The following indicates the pinout of the camera's terminal power connector.
Installation & Connections
Adjusting Zoom and Focus
Follow the steps below to adjust the zoom and focus of the camera's lens.
1. Detach the camera's sunshield by loosening the top screws.
2. Turn the front cover counterclockwise to remove the front cover. Unlock the
zoom and focus lever labelled 1 and 2 by turning the knob counterclockwise.
Then move the levers to adjust the zoom and focus. Use no.2 lever for adjusting
focal length, and no.1 lever for fine-tuning focus.
3. Tighten the levers after the adjustment. Then re-install the lens cover and
sunshield.
3
Pin
1
+ 12V DC
2
COM
3
24V AC
Note:
The camera comes with two desiccant packs inside the housing,
one at the front end and the other at the rear end. Make sure you
put them in place whenever you open the housing to protect
against excessive humidity.
2
1
Function
1
2
Installation & Connections
5
Advertisement
Table of Contents
