Table of Contents
Advertisement
McAfee® IntruShield® IPS 4.1
IntruShield Sensor 4000 Product Guide
Working with Fiber-optic ports
Warning:
optic port. Invisible radiation might be emitted from the aperture of the port when
no fiber cable is connected.
Usage restrictions
The following restrictions apply to the use and operation of an IntruShield sensor:
Unpacking the sensor
To unpack the sensor:
1
2
3
4
5
6
7
8
Contents of sensor box
The following accessories are shipped in the sensor box:
•
Fiber-optic ports (for example, FDDI, OC-3, OC-12, OC-48, ATM, GBIC, and
100BaseFX) are considered Class 1 laser or Class 1 LED ports.
•
These products have been tested and found to comply with Class 1 limits of
IEC 60825-1, IEC 60825-2, EN 60825-1, EN 60825-2, and 21CFR1040.
To avoid exposure to radiation, do not stare into the aperture of a fiber-
•
You may not remove the outer shell of the sensor. Doing so will invalidate
your warranty.
•
The sensor appliance is not a general purpose workstation.
•
McAfee prohibits the use of the sensor appliance for anything other than
operating the IntruShield IPS.
•
McAfee prohibits the modification or installation of any hardware or
software in the sensor appliance that is not part of the normal operation of
the IntruShield IPS.
Place the sensor box as close to the installation site as possible.
Position the box with the text upright.
Open the top flaps of the box.
Remove the accessory box.
Verify you have received all parts. These parts are listed on the packing list and
in Contents of the sensor box.
Pull out the packing material surrounding the sensor.
Remove the sensor from the anti-static bag.
Save the box and packing materials for later use in case you need to move or
ship the sensor.
•
one sensor
•
one CD-ROM containing the sensor software and on-line documentation.
10
Before you install
Working with Fiber-optic ports
- Quick Links:
- Cabling the Console Port
Hide quick links:
Advertisement
Table of Contents
