Cub Cadet TANK SZ 54 Operator's Manual page 36

Replacing the PTO Belt
1. Remove the PTO belt from the deck as instructed in the
Deck Removal section then remove it from around the PTO
clutch. See Figure 7-5.
2. Route the PTO belt as shown in Figure 7-5. After routing the
belt around the PTO pulley, use a 1⁄2" drive in the idler pulley
bracket and turn towards the right of the tractor to finish
routing the belt around the idler pulley.
3. Reinstall the deck.
Replacing the Deck Belt
1. Set the parking brake. Remove ignition key and both spark
plug caps.
2. Remove the PTO belt, (refer to Deck Removal on page 34).
3. Pull the four latches up and rotate 1/4 turn to line up with
the slots in the deck covers and remove both covers. See
Figure 7-6.
36 S 7— S
ection ervice
PTO Clutch
PTO Belt
Figure 7-5
Figure 7-6
4. Using a 1⁄2" drive insert the male end into the 1⁄2" square
opening in the deck idler assembly and rotate the idler
clockwise. See Figure 7-7. While holding the deck idler,
loosen the deck belt from the pulley and slide the belt
away from the pulley.
Figure 7-7
WARNING!
Avoid pinching injuries. Never place
your fingers on the idler spring or between the belt
and a pulley while removing the belt.
5. Route the new belt as shown in Figure 7-7. Then reinstall
the deck and PTO belt as instructed on pages 33-34.
Deck Idler Bracket