Air Conditioner Use; Starting Your Air Conditioner; Mode; Fan Speed - Haier ESA405K Use And Care Manual

Operating your air conditioner properly helps you to obtain the
best possible results.
This section explains proper air conditioner operation.
IMPORTANT:
If you turn off the air conditioner, wait at least 3 minutes before
turning it back on. This keeps the air conditioner from blowing a
fuse or tripping a circuit breaker.

MODE

SPEED TIMER
FAN HIGH
COOL MED
ENERGY LOW
SAVER
DEHUM
2. Press POWER to turn on the air conditioner. The Power
indicator light will turn on.
NOTE: When the air conditioner is plugged in, the LED display will
show "88" for 3 seconds. After the air conditioner is turned on for
and the fan is set to Low speed.
After the unit is plugged in, but before the unit is turned
on, press and hold the POWER button for 5 seconds to
switch the temperature display between Fahrenheit (F)
and Celsius(C) degrees.
3. Select mode. See "Mode."
4. Select fan speed. See "Fan Speed."
5. Set temperature. See "Temperature."
Mode
1. Press MODE until you see the indicator light glow for the
desired setting.
2. Choose Fan, Cool, Energy Saver or Dehum.
Fan—Only the fan runs to provide air circulation. Press
SPEED to select High, Med or Low fan speed. The display
shows the current room temperature.

AIR CONDITIONER USE

Starting Your Air Conditioner

TEMP / TIME
ON
OFF
POWER
POWER
Do not try to operate your air conditioner in the Cool mode when
outside temperature is below 61°F (16°C). The inside evaporator
coil will freeze up, and the air conditioner will not operate
properly.
Cool—Cools the room. Press SPEED to select High, Med or
Low fan speed. Press the TEMP/TIME up or down
arrow button to set the desired temperature.
Energy Saver—Fan runs only when cooling is needed. Press
SPEED to select High, Med or Low fan speed.
Because the fan does not circulate the room air continuously,
less energy is used, but the room air is not circulated as often.
Dehum—Dries the room. The air conditioner automatically
selects the temperature.
NOTE:
Dehum mode should not be used to cool the room.
In Dehum mode,Please do not operate the speed button.
MODE

Fan Speed

1. Press FAN SPEED until you see the indicator light glow for
the desired setting.
2. Choose High, Med or Low.
High—for maximum cooling
Med—for normal cooling
Low—for minimum cooling
SPEED
FAN
COOL
ENERGY
SAVER
DEHUM
HIGH
MED
LOW
9