Table of Contents
Advertisement
EasyLink
The IP Camera is bundled with free Level1DNS
unique user name to their network camera's IP address. There is no need to configure the
router to open up ports or remember hard-to-memorize IP addresses. The default domain
name is MAC address, you can also register your own name on-line but it have to check
the available first.
1. Check the box to enable EasyLink function.
2. If Auto mode is selected, the following page will be displayed.
NOTE - This mode is recommended.
3. Enter a unique EasyLink name whose length must be between 5-32 characters.
Verify that the EasyLink name is available.
Click Apply to apply settings or Cancel to cancel changes.
NOTE - The EasyLink function will not work if the following conditions occur:
1. The camera cannot be located behind a double NAT network.
2. The camera's IP address cannot be assigned to specific port numbers using the
router's port forwarding.
3. EasyLink uses UPnP to exchange port information with the router. The camera must
be connected to the internet through a router which supports UPnP.
service which allows users to assign a
TM
- 36 -
Advertisement
Table of Contents
