Operation; Rear Panel Control; Remote Control - JBL ESC 300 Setup Manual

three.

Operation

Remote Control Battery Installation.
Push small tab towards
battery slot and pull battery
drawer out.

Rear Panel Control

AC
230V 50Hz
˜
Master On/Off Switch
To operate unit, place this switch in the On/Standby
position. The system will go into standby when no
signal has been received for approximately five
minutes.

Remote Control

1. Mute
From either the front panel
or the remote control, press
(Mute) to lower the volume
completely. The mute symbol
indicator (27) will begin to flash.
When you press either
of the mute buttons again, the
volume will return to its previous
setting. Note: The mute function
can also be turned
off by pressing either of the
volume buttons on the front
panel or the remote control.
Remove old battery.
2. 0dB
Press this button to reset the
Center, Surround, Balance,
Treble, and Bass controls to
their default positions.
3. Test
Press this button to activate
the Test Tone mode (see "Test
Tone" section).
Insert new battery with "+" side
up, and slide battery
drawer back into remote.
MUTE
1
2
0dB
TEST
3
SURROUND
MODES
10
Pro
Logic
11
Phantom
12
Simulated
13
3 Stereo
14
Stereo
4. Volume
Press ( ) on the remote
control or the front panel
to raise the system's volume.
Press ( ) on the remote
control or the front panel to
lower the system's volume.
5. Center
Press (+) on the remote control
to increase the relative volume
of the center channel. Press (–)
on the remote control to
decrease the relative volume of
the center channel.
VOLUME
4
CENTER
5
+
–
SURROUND
6
+
–
BALANCE
7
L R
TREBLE
8
+
–
BASS
9
– +
16
INPUT
Video Aux
15
TM