Operation; Rear Panel Control; Remote Control - JBL Simply Cinema ESC300 Simple Setup Manual

three.

Operation

Remote Control Battery Installation.
Push small tab towards
Remove old battery.
battery slot and pull battery
drawer out.

Rear Panel Control

Master On/Off Switch
To operate unit, place this switch in the
On/Standby position. The system will go into
standby when no signal has been received for
approximately five minutes.

Remote Control

1. Mute 2. 0dB
From either the front panel or Press this button to reset the
the remote control press (Mute) Center, Surround, Balance,
to lower the volume completely. Treble, and Bass controls to
The mute symbol indicator (27) their default positions.
will begin to flash. When you
press either of the mute but- 3. Test
tons again, the volume will Press this button to activate
return to its previous setting. the Test Tone mode (see "Test
Note: The mute function can Tone" section).
also be turned off by pressing
either of the volume buttons on
the front panel or the remote
control.
All manuals and user guides at all-guides.com
Insert new battery with "+"
side up, and slide battery
drawer back into remote.
MUTE VOLUME
1
2
0dB
TEST CENTER
3
– +
SURROUND
– +
SURROUND
MODES
BALANCE
10
Pro
L R
Logic
TREBLE
11
– +
Phantom
BASS
12
– +
Simulated
13
3 Stereo
INPUT
Video Aux
14
Stereo
TM
4. Volume
Press ( ) on the remote con-
trol or the front panel to
raise the system's volume.
Press ( ) on the remote con-
trol or the front panel to
lower the system's volume.
5. Center
Press (+) on the remote con-
trol to increase the relative
volume of the center channel.
Press (–) on the remote con-
trol to decrease the relative
volume of the center channel.
4
5
6
7
8
9
16
15