Honda iGX240 Owner's Manual page 11

4. Clean the foam filter element if it is to be reused.
Clean in warm soapy water, rinse, and allow to dry thoroughly. Or
clean in non-flammable solvent and allow to dry.
Dip the filter element in clean engine oil, then squeeze out all
excess oil. The engine will smoke when started if too much oil is
left in the foam.
Soak Squeeze
5. Wipe dirt from the inside of the air cleaner case and cover, using
a moist rag. Be careful to prevent dirt from entering the air duct
that leads to the carburetor.
6. Install the foam filter element to the air cleaner case.
7. Install the air cleaner cover and snap the air cleaner cover clips.
SEDIMENT CUP
Cleaning
Gasoline is highly flammable and explosive, and you
can be burned or seriously injured when handling
fuel.
Stop the engine and keep heat, sparks, and flame
away.
Handle fuel only outdoors.
Wipe up spills immediately.
(LOW PROFILE TYPES)
1. Unsnap the air cleaner cover clips, remove the air cleaner cover,
and remove the foam filter element (see page
2. Remove the four 5 mm flange bolts, one 6 mm flange bolt, and
air cleaner case.
Remove the two 6 mm flange nuts and pull out the breather tube,
then remove the air cleaner base.
LOW PROFILE TYPES
BREATHER TUBE
6 mm FLANGE NUTS
5 mm FLANGE BOLTS
Dry
Oil Squeeze
10 ).
AIR CLEANER BASE
AIR CLEANER CASE
5 mm FLANGE
BOLTS
6 mm FLANGE BOLT
3. Move the fuel valve lever to the OFF position.
4. Remove the fuel sediment cup, O-ring and filter.
5. Wash the sediment cup in non-flammable solvent, and dry it
thoroughly.
FILTER
(Viewed from
the bottom)
Align
6. Reinstall the sediment cup as shown. Tighten the sediment cup
securely.
(LOW PROFILE TYPES)
7. Install the air cleaner base, breather tube, air cleaner case, foam
filter element, and air cleaner cover in the reverse order of
removal.
ENGLISH
FILTER
O-RING
SEDIMENT CUP
11