Installing The Optional Ai 02, Analog Input / Output - Samson D3500 Owner's Manual

Installing the Optional AI 02, Analog Input / Output

Installing the AI01 / 02, Analog Input / Output
1. Open the top cover by removing the six screws shown
in Figure 1.
2. Remove the four screws of the blank panel and the
panel itself.
3. Thread the two ribbon wires through the slot. Install
the panel into the chassis using the four screws re-
moved in step 2. (See Figure 2)
4. If the AI01 (or 02) is mounted into the upper chassis
slot, attach the end of the large, gray ribbon con-
nector into the socket labeled JP2 on the D-CLASS
DSP MAIN printed circuit board. If the AI01 (or 02) is
mounted into the lower chassis slot, attach the large
ribbon connector into the socket labeled JP1. There is
a notch in the socket that must line up with the tab on
the bottom of the connector. (See Figure 3)
5. Carefully push down on the connector and it will
engage the locking tabs on either side.
6. Attach the end of the small ribbon cable connector
to the jack labeled CN5 (and / or CN7 if installing a
second Analog I/O) on the D-CLASS POWER printed
circuit board. Note that the two notches on the con-
nector must line up with the notches on the jack. Push
the plug down into place. (See Figure 3)
7. Slide the top cover back on and replace the six screws.
D3500_ownman_v1_2.indd 23
Figure 1 Figure 1
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES
CLASS B. OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS: (1) THIS DEVICE MUST NOT CAUSE HARMFUL
INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED INCLUDING INTERFERENCE THAT
MAY CAUSE UNDESIRED OPERATION.
Figure 2 Figure 2
���
Figure 3 Figure 3
23
���
9/4/05 5:21:36 PM