Using The Limiter For Basic Speaker Protection; Setting An Eq Contour Using The Hp / Lp; Operating The D3500 - Samson D3500 Owner's Manual

The HP / LP Switch Has Four Clicks!
Click Menu Function
1 Lowpass high Cut Filter 2 kHz - 20 kHz
2 Lp-Order Filter Slope
3 Highpass low Cut Filter
4 HP-Order Filter Slope
• Press the HP / LP switch so that the yellow LED is lit.
• Engage the effect by pressing the IN / OUT switch
until the yellow LED lights.
• To set the High-pass filter press the HP / LP switch
until the LCD display reads; High-pass.
• Now, use the Data Wheel to set the frequency from 20
Hz to 200 Hz.
• Press the HP / LP switch again and you will see the
menu to set filter Order, or slope. The menu will read
HP-Order.
• Use the Data Wheel to choose a slope of either 6dB,
12dB, or 18 dB.
Note: If you want to use the Low Pass filter but not the High
Pass filter set the Low Pass filter slope to 0 dB.
• To set the Low-pass filter, press the HP / LP switch
until the LCD display reads; Low-pass.
• Now, use the Data Wheel to set the frequency from 20
Hz to 20 kHz.
• Press the HP / LP switch again and you will see the
menu to set filter Order, or slope. The menu will read
LP-Order.
• Use the Data Wheel to choose a slope of either 6dB,
12dB, or 18 dB.
Note: If you want to use the High Pass filter but not the
LowPass filter set the High Pass filter slope to 0 dB.
D3500_ownman_v1_2.indd 15
Value
0, 6, 12, 18 per Octave
20 Hz - 200 Hz
0, 6, 12, 18 per Octave
��
�
� � � �
�����
�
� � � �
������
��

Operating the D3500

Using the LIMITER for Basic Speaker Protection

In order to help you protect your speaker system, the
D3500 employs a digital Limiter. When engaged, the
digital Limiter will prevent signals from reaching outputs
levels over a desired point. The D3500's Limiter has a vari-
able Threshold level, which is the point the limiter circuit
begins to attenuate the system. The Limiter also has a
variable Release time, which is the time the limiter circuit
takes to return the signal to the original level.
The LIMITER Switch Has Two Clicks!
Click Menu Function
1 Lim. Thr. Threshold
2 Lim. Rel. Release Time
To operate the D3500 digital LIMITER follow these simple
steps.
• Press the LIMITER switch so that the yellow LED is lit.
• Now, engage the effect by pressing the IN / OUT
switch until the yellow LED lights.
• To access the Threshold parameter, press the LIMITER
switch until you see the menu, Lim. Th. The LIMITER
Threshold can be set from –100 dB to 0 dB.
• To access the Release parameter, press the LIMITER
switch until you see the menu, Lim. Rel. The LIMITER
Release time can be set from 50 to 100 % (equivalent
to 2 to 15 seconds).
�����
������
15
Value
0 to -100 dB
50 to 100 % (equiv
alent to 2 to 15 sec-
onds)
��
� � � �
��
� � � �
9/4/05 5:20:12 PM