Selecting A Midi Channel - Samson D3500 Owner's Manual

Operating the D3500
Now that you have enabled the D3500 for D-Net, as
described in the previous section, you can select addition-
al MIDI parameters that may be necessary for your exact
application or system set-up. The D3500's MIDI has three
basic modes of operation Channel, Omni and System
Exclusive and Program. The D3500 can operate in any of
these three MIDI modes.
One of the most used MIDI modes is Channel MIDI, which
allows you to assign up to sixteen different devices to indi-
vidual MIDI channels 1 through 16.

Selecting a MIDI Channel

You can program the D3500 to receive MIDI messages on
a specific MIDI channel by following the next step:
• Press the MIDI switch until that LCD reads M: Channel 1.
• Use the Data Wheel to select M: Channel 1 - 16. Press
store.
Selecting MIDI Omni mode
You can program the D3500 to receive MIDI messages in
Omni mode by following the next steps.
• Press the MIDI switch until that LCD reads OMNI.
• Use the Data Wheel to select Omni ON. Press store.
Selecting MIDI System Exclusive Mode
You can program the D3500 to receive or transmit MIDI
System Exclusive messages. Program the D3500 for System
Exclusive operation by following these simple steps:
• Press the MIDI switch until that LCD reads SysEx. OFF to
access the MIDI System Exclusive menu.
• Now, select one of the transmit and receive modes.
• If you want the D3500 to transmit system exclusive mes
sages, use the Data Wheel to select Sys Ex. TR. Press
store.
D3500_ownman_v1_2.indd 18
• In order to set the D3500 to receive system exclusive
messages, use the Data Wheel to select SysEx. Rc. Press
store.
• If you want the D3500 to receive and transmit system
exclusive messages, use the Data Wheel to select SysEx.
T + R. Press store.
• Use the Data Wheel to select SysEx. OFF, press store
and the D3500 will not transmit or receive any system
exclusive messages.
Selecting MIDI Program Change
You can program the D3500 to receive or transmit MIDI
Program messages. Program the D3500 for MIDI Program
Change operation by following these simple steps.
• Press the MIDI switch until that LCD reads Pgm Ch. to
access the MIDI Program Change menu.
• Now, select one of the transmit and receive modes.
• If you want the D3500 to transmit system exclusive mes-
sages, use the Data Wheel to select Pgm Ch. Tr. Press
store.
• In order to set the D3500 to receive system exclusive
messages, use the Data Wheel to select Pgm Ch. Rc.
Press store.
• If you want the D3500 to receive and transmit system
exclusive messages, use the Data Wheel to select Pgm
Ch T + R. Press store.
• Use the Data Wheel to select Pgm Ch OFF, press store
and the D3500 will not transmit or receive any system
exclusive messages.
18
9/4/05 5:20:14 PM