Upper Front Mount; Eye Clamp Assembly - Champion Sidecars DAYTONA 2+2 Owner's Manual

Upper Front Mount (1984 through 2003)

Eye Clamp Assembly

Install the strap clamp (figure 5) as high as possible on the
right side vertical frame tube. Do not tighten the eye bolt at
this time . Note: Be sure to install the two 1/4 bolts from the
rear with the nuts facing forward to allow sufficient
clearance between the volt heads and the engine.
(FIG 6)
Remember the engine moves
when it is running and if the
clamp bolts are too close it
could damage the head finish.
7)
Lower Front Mount (figure 7 & 8)
Remove the two socket head cap screws holding the right floorboard.
Remove the bolt holding the bottom of the crash guard. Install the mount
between the crash guard and the frame and replace the crash guard bolt
Align the mount slots with those for the floorboard and replace the
floorboard. Now tighten all bolts .
13
(FIG
(FIG 8)
(FIG 5)