Hardware Instructions - Champion Sidecars DAYTONA 2+2 Owner's Manual

10
1996 - 1997 Harley Davidson FLH Hardware Instructions
Figure 1
1. Remove the seat.
2. Remove the right side passenger and driver foot rest.
(Allen hex head bolt)
3. Remove the front lower crash bar bolt.
4. Remove the saddlebag crash bar upper mount.
5. Take the rear mount Fig 1 and starting with the
passenger foot rest put the bolts in place from the center
out. Leave the bolts loose until the lower rear and upper
rear mounts are connected together Fig 3 # 2 and all the
bolts are in place.
6. Now install the lower rear mount to the frame rails as
shown in Fig #2 . Now tighten all bolts to the upper rear
mount and the lower rear mount.
If you are installing the sidecar to a FLHTCU with
front lower leg guards it will be necessary to remove
the right side. (This part will not be reinstalled)
1. Number 1 of (figure 2) shows the location of crash bar
mount located under the seat (position the mount under
the factory crash guard). Figure 2
2. Number 2 of (Figure 1) shows the
location of the mount to the foot rest bolt.
3. # 1 and # 2 of (figure 2) shows the
location of the lower rear sub frame to the
motorcycle frame. Take notice of the
clamp location and the bolts supplied by
Champion.
4. Number 2 of (figure 3) shows the bolt
supplied by Champion that is used to
connect the upper rear and lower rear sub-
frame together.