Advertisement
Assembly
1. Remove the grounds bin from
the unit and set aside.
2. Remove the single Phillips
head screw from the center rear of
the rear metal casting cover and
slide the rear casting rearward
1cm to remove it. (see photo #1).
Photo #1
3. You must remove the rub-
ber feet from the bottom of the
grinder. Use a pair of side cut-
ters or a butter knife to pry the feet
out. (See photo #2).
Photo #2
4. Coil as much of the cord into
the hole in the bottom of the
grinder, about 1/3 will fit.
(see photo #3).
4
Photo #3
Advertisement
