Argox A-2240 User Manual page 34

LED Indicators: Power and Ready LEDs blink alternately
Power LED Ready LED
ON OFF
OFF ON
Possible Problems
Ribbon out Supply the ribbon roll
Ribbon jam Recover the jam
Ribbon sensor error Replace ribbon
sensor
LED Indicators: Only the Power LED blinks
Power LED Ready LED
ON ON
OFF ON
Possible Problems
Serial IO error Check the baud rate Serial interface
Memory full Add the extension
RAM(flash memory
card)
Cutter failed, or jam Check the cutter
at cutter
Recover the jam
Hardware error Call for service
A Series User's Manual
Solutions Remarks
Not applicable
to direct
thermal type.
Solutions Remarks
only
Occurs only when
installing or setting
the cutter
67
LED Indicators: Only the Ready LED blinks
Power LED Ready LED
ON ON
ON OFF
Possible Problems
Print head too hot Printing will stop until
the print head cools to
an acceptable printing
temperature. When it
does, the printer will
automatically resume
operation.
Printer head module Make sure that printer
uncovered head module has
been covered.
A Series User's Manual
Solutions Remarks
68