Output Status Display - Fostex FM-4 Owner's Manual

<Memo>: If you switch the microphone power
supply switch of INPUT 1 to "T12", the input
status display changes as below .
If you set the microphone power supply switch
of INPUT 1 to "T12" and set the microphone
power supply switches of INPUT 2 through IN-
PUT 4 to "P48", the input status display looks
as follows .
(3) Press the [EDIT] key to exit the status display
mode .
The display changes to the meter display .
<Note>: If you need to supply the T12 power,
set the T12 power supply function to "ENA" by
the similar procedure as above .
<Memo>: The T12 disabled/enabled setting re-
mains even after you turn off the unit . However,
if you initialize the flash memory using the sys-
tem status display, it is reset to the default "ENA"
setting (see page 24) .

Output status display

On the output status display, you can see the current
status of the switches related to the outputs as well
as the output sources .
Depending on the [SOURCE SEL] switch setting, the
display looks as below .
When the [SOURCE SEL] switch is set to "MIX"
The display shows the status of the switches shown
below, as well as the output sources . The following
shows the default setting when the unit is shipped .
You can set the threshold and ratio of the limiter from
this display .
Front panel
Right side panel
When the [SOURCE SEL] switch is set to "DIRECT
OUT"
The display shows the status of the switches shown
below, as well as the output sources . The following
shows the default setting when the unit is shipped .
Right side panel
0
Right side panel
Right side panel
Right side panel
Right side panel