Westinghouse WSE7000S, WSE7000P, WSE7000W,WSE6970S, WSE6970P, WSE6970W,WSE6070S User Manual page 21

iNStALLiNG YoUR icE ANd wAtER fiLtER
Step 16
Remove ice cream shelf (in freezer) to access and switch on
ice maker
ICE MAKER ON OFF SWITCH
OFF ON TEST
ER ON OFF SWITCH
FOR SERVICE
USE ONLY.
HOLD DOWN
FOR 15 SECS.
ON TEST
FOR SERVICE
USE ONLY.
HOLD DOWN
FOR 15 SECS.
Step 17
After 24 hours remove ice bin and dispose of first few
batches of ice to ensure that impurities have been flushed
from the system.
ICE MAKER ON OFF SWITCH
OFF ON TEST
FOR SERVICE
USE ONLY.
HOLD DOWN
FOR 15 SECS.
tipS ANd USEfUL iNfoRMAtioN
Ensure that taps are turned off when replacing and fitting
filters. Remember to turn the taps back on when filter fitting
is complete.
Ensure that the water pressure has been checked prior
to installation as high or low water pressure can cause
problems with the Ice & Water dispenser. Water pressure
problems can be easily rectified by your qualified installer.
Always fit filter as per manufacturer's instructions, paying
special attention to water flow direction.
If you need to replace water tube, only use approved water
quality piping that meets the pressure requirements.
Do not allow the water tubing to become kinked
or wrapped under the refrigerator when moving the
refrigerator back into position.
Make sure your refrigerator is level to avoid uneven
ice cubes.
After installation, run the water dispenser for a few minutes to
ensure that all air bubbles have been purged from the tubing.
Dripping may occur if air bubbles remain in the tube.
Replace filter at suggested intervals to avoid water/ice
reduction and irregularities in taste.
Remove and clean ice bin once a month, discarding
unused ice cubes. This will ensure fresh, clean ice and
smooth operation of your ice maker.
Clean and empty the dispenser drip tray regularly to
avoid overflow.
As the water/ice cut off is not instant, leave glass under
dispenser briefly until water or ice has stopped flowing to
avoid spills.
Always place ice in glass before filling with water to
avoid splashing.
INSTALLATION
21