Glide 'N' Serve; Crisper Humidity Control - LG GM-B208ST Owner's Manual

Sliding Shelves (in some models)
You can slide some of the shelves in your refrigerator
towards inside or outside like explained below.
• To slide the shelf towards the outside: Pull towards
you, figure A.
• To slide the shelf towards the inside: Push until it
stops, figure B.
Figure A
In order to remove a shelf from a metal frame
• Pull the shelf until it stops.
• Incline the front of the shelf towards the top and pull
forward.
• Lift the shelf in the manner it moves across the
support openings.
To put back into place just reverse these steps.
Functional Shelves (Folding Shelves, in some models)
You can store tall articles like gallons or bottles just by
simply folding the shelf in half.
GLIDE'N'SERVE (in some models)
For storage of meat or fresh food. Adjust the control
to desired temperature by moving from COLD to
COLDER.
Pull forward to open. Lift slightly and pull it out to
remove.
USING YOUR REFRIGERATOR
CRISPER HUMIDITY CONTROL (in some models)
You can control the amount of humidity in the
moisture-sealed crispers. Adjust the control to any
setting between HIGH and LOW.
Figure B
To remove the crisper:
To remove the glass:
To remove the crisper cover support:
NOTE: Remove glass before removing the crisper cover
support.
22
• "High": keeps moist air in the crisper for best storage
of vegetables.
• "Low": lets moist aire out of the crisper for best
storage of fruits.
I I
I
• Slide crisper straight out to the stop.
• Lift the front of the crisper, then pull it out to remove
• Replace the crisper by sliding it back in fully past the
drawer stop.
CAUTION:
Be careful when you handle the glass
cover because it could loose.
• Lift up the glass after inserting a screwdriver under
the crisper cover.
• Pull glass cover up and out.
• While holding the crisper cover support with both
hands (as shown in the image below). Pull forward
and slightly lift the front part.
I I
I
I