Table of Contents
Advertisement
CW2900 Installation and Operation Manual
Appendix 3: Faceplate Installation
Remove the faceplate panels from their box and follow the installation instructions below;
Contents: (4) - #10-24 x 1/2" bolt
(4) - #10-24 hex nut
(2) – 1/2" x 3" spring
Place the faceplate panels with the finished side down on a flat, soft, non-abrasive surface.
Line up the holes from of the upper panel with the holes of side panel and secure them
together using the bolts and nuts provided. Repeat this operation to assemble the other
side panel.
Note: If the installation of a heat radiation shield is required to reduce clearances from the
shelf and top surround, refer to Appendix 4: Top Surround and Mantel Shelf Heat
Shield Installation (AC01317) prior to the installation of the faceplate on the insert.
50
Advertisement
Table of Contents
