Notes On Schematic Diagram - Sharp MD-R2 Serivce Manual

Hide thumbs Also See for MD-R2:

Operation manual (40 pages)

Table of Contents

• Resistor:

To differentiate the units of resistors, such symbol as K and

M are used: the symbol K means 1000 ohm and the symbol

M means 1000 kohm and the resistor without any symbol is

ohm-type resistor. Besides, the one with "Fusible" is a fuse

type.

• Capacitor:

To indicate the unit of capacitor, a symbol P is used: this

symbol P means micro-micro-farad and the unit of the

capacitor without such a symbol is microfarad. As to electro-

lytic capacitor, the expression "capacitance/withstand volt-

age" is used.

(CH), (TH), (RH), (UJ): Temperature compensation

(ML): Mylar type

(P.P.): Polypropylene type

• Schematic diagram and Wiring Side of P.W.Board for this

model are subject to change for improvement without prior

notice.

• The indicated voltage in each section is the one measured by

Digital Multimeter between such a section and the chassis

with no signal given.

1. In the tuner section,

( ) indicates AM

< > indicates FM stereo

2. In the main section, a tape is being played back.

3. In the deck section, a tape is being played back.

( ) indicates the record state.

4. In the power section, a tape is being played back.

5. In the CD section, the CD is stopped.

• Parts marked with "

" (

maintaining the safety of the set. Be sure to replace these

parts with specified ones for maintaining the safety and

performance of the set.