Bunn TB3 Installation & Operating Manual
  1. Manuals
  2. Brands
  3. Bunn Manuals
  4. Kitchen Appliances
  5. TB3
  6. Installation & operating manual

Bunn TB3 Installation & Operating Manual

Tb3 series; tb6 series
Hide thumbs Also See for TB3:
Table of Contents

Advertisement

Quick Links

See also: Service & Repair Manual , Operation & Service Manual
INSTALLATION & OPERATING MANUAL
To ensure you have the latest revision of the Operating Manual, or to view the Illustrated Parts
Catalog, Programming Manual, or Service Manual, please visit the Bunn-O-Matic website, at
www.bunn.com. This is absolutely FREE, and the quickest way to obtain the latest catalog and
manual updates. For Technical Service, contact Bunn-O-Matic Corporation at 1-800-286-6070.
41465.0001B 01/10 ©2008 Bunn-O-Matic Corporation
BUNN-O-MATIC CORPORATION
POST OFFICE BOX 3227
SPRINGFIELD, ILLINOIS 62708-3227
PHONE: (217) 529-6601 FAX: (217) 529-6644
TB3/TB6 Series
Including: TB3; TB3-LP;
TB3Q; TB3Q-LP; TB6; TB6Q
STARTING WITH SERIAL NUMBER: TU00020000

Advertisement

Table of Contents
loading

Related Manuals for Bunn TB3

Summary of Contents for Bunn TB3

  • Page 1 To ensure you have the latest revision of the Operating Manual, or to view the Illustrated Parts Catalog, Programming Manual, or Service Manual, please visit the Bunn-O-Matic website, at www.bunn.com. This is absolutely FREE, and the quickest way to obtain the latest catalog and manual updates. For Technical Service, contact Bunn-O-Matic Corporation at 1-800-286-6070.

  • Page 2: Warranty

    SOLE OPTION AS SPECIFIED HEREIN, TO REPAIR, REPLACEMENT OR REFUND. In no event shall BUNN be liable for any other damage or loss, including, but not limited to, lost profi ts, lost sales, loss of use of equipment, claims of Buyer’s customers, cost of capital, cost of down time, cost of substitute equipment, facilities or services, or any other special, incidental or consequential damages.

  • Page 3: Table Of Contents

    FAILURE TO COMPLY RISKS EQUIPMENT DAMAGE, FIRE, OR SHOCK HAZARD READ THE ENTIRE OPERATING MANUAL BEFORE BUYING OR USING THIS PRODUCT PN: 00658.0000G 02/08 © 1985 BUNN-O-MATIC CORPORATION THIS APPLIANCE IS HEATED WHENEVER CONNECTED TO A POWER SOURCE #00658.0000 00831.0000F 3/98 ©1998 BUNN-O-MATIC CORPORATION #03409.0000...

  • Page 4: Electrical Requirements

    ELECTRICAL REQUIREMENTS CAUTION - The brewer must be disconnected from the power source until specifi ed in Initial Set-Up. 120V model brewers require 2-wire, grounded service rated 120 volts ac, 15 amp, single phase, 60 Hz. "A" model brewers require 2-wire, grounded service rated 230 volts ac, 10 amp, single phase, 50 Hz. "B"...

  • Page 5: Plumbing Requirements

    50 psi (345 kPa). The water inlet fi tting is .75-11.5 NH (HOSE THREAD). For convenience an elbow adaptor is provided to convert to a ¼˝ fl are fi tting. Bunn-O-Matic does not recommend the use of a reverse-osmosis or deionized water supply to this equipment.

  • Page 6: Initial Set-Up (Tb3Q)

    INITIAL SET-UP (TB3Q/TB3Q-LP/TB6Q ONLY) CAUTION - The brewer must be disconnected from the power source throughout the Initial Set-Up, except when specifi ed in the instructions. Remove the top cover from the brewer. Rotate the control thermostat knob fully counterclockwise to the "OFF" position and replace the top lid. Insert an empty funnel into the funnel rails.

  • Page 7: Initial Set-Up (Tb3)

    23. Reinstall the metal discharge tip into the funnel. 24. Load the funnel with a BUNN® paper fi lter and approximately four ounces of loose tea leaves. 25. Place the ON/OFF switch in the "ON" position, momentarily press the start switch, and allow both the concen- trate and dilution cycles to occur.

  • Page 8: Auto Sweetener Set-Up

    After the desired volume has been set, turn the water supply on. Reinstall the top lid and rear panels. The brewer may now be returned to service. (TB3/TB3-LP ONLY) Set the "Delay knob on the dilution timer to the 3 minute setting. (The minimum delay setting) Plug brewer into the power source.

  • Page 9: Adjusting Brew Volumes

    1. To adjust concentrate volume on TB3/TB6 models, and dilution volume on TB3Q/TB6Q models: Modifying batch sizes. To modify a batch volume, fi rst check that the SET/LOCK switch is in the “SET”...

  • Page 10: Operating Controls

    Begin each brew cycle with a clean empty brew funnel and server. (Be sure the server lid doesn’t interfere with the fl ow of dilution water.) Insert a BUNN® fi lter into the funnel. Pour the packet of loose fresh tea leaves into the fi lter. Approximately three to fi ve ounces is recommended for three gallons of beverage.

  • Page 11: Cleaning

    CLEANING CAUTION - CLEAN AND SANITIZE YOUR ICED TEA BREWER DAILY DAILY: 1. Remove, disassemble and thoroughly clean and sanitize the entire brew funnel. The funnel tip and screen must be free from any tea particles or residue. Reassemble the funnel. 2.

This manual is also suitable for:

Tb3-lpTb3q-lpTb3qTb6Tb6q

Table of Contents