Step 3 - Test Fit Your Lightspeaker ® 5; Step 4: Installing The Trim Ring - Klipsch LightSpeaker Owner's Manual

State-of-the-art light & sound

Hide thumbs Also See for LightSpeaker:

Table of Contents

Step 3: Test fit your LightSpeaker

Your LightSpeaker

5" (R30) and 6" (R40) down light cans by simply removing

the existing light and, in the same manner as a light bulb,

re-installing your LightSpeaker

simply test fit your LightSpeaker

If your LightSpeaker

lighting fixture without any modifications you can skip

forward to Step 6.

If your LightSpeaker

trim ring/reflector opening is too small or the lighting

fixture is not set deep enough, please go to www.klipsch.

com or refer to your Complete System Manual.

Your LightSpeaker

trim ring. There are two different sizes. Choose

your trim ring based on either A or B below and place

the LightSpeaker

LightSpeaker

Upon completion of the install, this trim ring should fit

snuggly and uniformly to the ceiling and should also seat

properly around the entire edge of your LightSpeaker

A) The thicker trim ring will be used when your

LightSpeaker

Tech Support: 1-800-KLIPSCH

5 is designed to fit directly into most

5 fits directly into your recessed

5 does not fit either because the

5 comes with their own integrated

5 trim ring over the back of the

5. Be sure the finished side is facing out.

5 is installed into a 6" lighting fixture.

5 in its place. You may

Table of Contents

Lightspeaker 5