Martin AF-1 MkII User Manual page 13

to set the DMX address to 101, you need to set DIP-switch pins 1, 3, 6
and 7 to ON, as shown in the illustration below:
3. Power the controller and all devices off.
4. For each device, set the DMX address by setting DIP-switch pins 1
through 9 to the ON (1) or OFF (0) position as listed in the table on the
next page. As an example, channel 101 is highlighted in the table.
DMX address DIP-switch settings
To use Table 2, first find the DMX address in the main block in the table.
Then read the settings for pins 1 - 5 to the left and read the settings for
pins 6 - 9 above the address. "0" means OFF and "1" means ON.
Installing control hardware 13