Table of Contents
Advertisement
09
Troubleshooting
(USB1, USB2 or
The device being recorded to
USB3) is now
has run out of space during the
full. The current
record process.
recording has
stopped.
A recording has
A USB device was not inserted
not started due to
in the correct slot when the
no device present
recording was scheduled to start
in (USB1, USB2 or
USB3).
(USB1, USB2 or
The USB device was removed
USB3) has been
when recording therefore the
removed. The
recording has stopped.
current recording
has stopped.
A recording has not
The USB device inserted in the
started as (USB1,
slot when the recording was
USB2 or USB3) is
scheduled to start was full.
full.
Device is too slow
The device inserted does not
to use.
meet the required specification
and will not work well with this
product.
8
Insert another device and press
[®]. You will lose some of the
programme. The recording will be
split over the 2 devices.
Insert a device and re schedule
the recording.
Re insert the device and re
schedule the recording.
Remove the full device. Insert
a device with free space and re
schedule the recording.
Use the 'Schedule record
summary' to check how
much free space is needed for
scheduled recordings.
Insert a compatible device. Please
refer to the 'Compatible devices
and formats' section on page 33.
Troubleshooting
General problem solving
What happens
What to do
You cannot see the
Select the AV channel using the button on your TV remote
opening picture (Press OK
control marked AV, EXT, TV/AV, O/E or a symbol, or read your TV
to start) from the digital
manual. Make sure both ends of your SCART cable are firmly
box.
connected to the relevant sockets. Make sure you followed the
instructions for setting up your digital box correctly.
Your remote control isn't
Make sure you are pointing the remote control directly at
working.
your digital box and that nothing is in the way. Check that the
remote-control light works when you press a button. Check the
batteries are in the right way round. Try replacing the batteries.
Subtitles do not appear
Some programmes broadcast without subtitles.
although they are set to
'on'.
The digital box does not
Is the green power light on? If the light is not on:
seem to work and there is
1.
press the [�] button on your remote control;
nothing shown on the TV.
make sure that all cables are firmly connected to the digital
2.
box and TV/VCR; and
3.
check that the digital box is properly plugged into the power
supply.
If the light is on:
1.
check you have the correct channel and input selected on
your TV;
2.
check that all cables are correctly attached;
make sure the VCR/DVD is switched off if it is connected to
3.
the digital box; and
4.
check if your VCR/DVD is causing the problem by
disconnecting the VCR/DVD.
The picture appears to be
Make sure your TV settings are correct. Please refer to page 30
'squashed' or 'cut off'.
of this guide.
I forgot to plug in the aerial
Switch off your digital box at the mains supply. Plug in the
when I set up the digital
aerial. Switch the digital box mains supply back on. Please read
box.
section about channel tuning.
09
9
Advertisement
Table of Contents
