Table of Contents
Advertisement
You can set three users for one IP Camera. One user is Administrator and others are Guest.
Administrator can set parameters for the IP Camera. However, Guest cannot set parameters.
Note:
Note:
Note:
Note:
User name can be composed of letters, numbers, underline or dot between 1 and 16
characters. Pay attention to the capitals and small letters
Default Administrator Name: admin
Default Guest Name: user1
Note: Pay attention to match capitals and small letters to User name and password
4.11
4.11
4.11
4.11 Terminal
Terminal
Terminal
Terminal
Terminal set:
Terminal
Terminal
Terminal
set:
set:
set:
Pan/Tilt Decoder connect with RS485 port. When there is control device to connect with IP Camera,
RS485 parameters need to be set according to the settings of the control device (Address, Protocol,
Bit rate), and download the corresponding protocol.
click the【save】button after setting
4.12
4.12
4.12
4.12 Storage
Storage
Storage
Storage set
set
set
set
4 4 4 4 . . . . 12
12. . . . 1 1 1 1 There
12
12
There
There is is is is Device
There
The device
The
The
The
device
device
device set
set as
set
set
user 2
\
.
Device
Device
Config
Config, , , , Record
Config
Record
Record
Device Config
Record set
as
as follows:
as
follows:
follows:
follows:
23/ 36
.
password: admin
password: user1
user 2
\
set
set
and
and
Snap
Snap
set
set in in in in Storage
set
set and
and Snap
Snap set
Storage
Storage
set.
set.
Storage set.
set.
Advertisement
Table of Contents
Need help?
Do you have a question about the Mega Pixel IP Camera and is the answer not in the manual?
Questions and answers