Installation Menu - Runco PlasmaWall PL-50HDX Owner's Operating Manual

Installation Menu

When the PFP Controller is turned on for the first time, the INSTALLATION item will not appear in the
main menu. To enable the INSTALLATION menu, there are two options:
· With the processor ON and no menus on-screen, simultaneously press the ENTER, UP and LEFT
buttons (you don't need to hold them down). Release the three buttons and press MENU, ensure
INSTALLATION is now on the bottom of the main menu.
· With the remote control, press button 6 (with no menus on-screen).
After pressing '6', press MENU and ensure INSTALLATION is now on the bottom of the main menu.
After INSTALLATION has been accessed, press MENU, highlight INSTALLATION and press ENTER.
This will bring up the INSTALLATION MENU, shown below:
INSTALLER MODE
SIDE BAR LEVEL
INVERT
OUTPUT SHIFT
INPUT SHIFT
IR CODE SELECT
19
OFF