Information About The Appliance; General Warnings - ICB HM-12 User Manual

1.1 GENERAL WARNINGS


The appliance must only be used after reading and understanding this manual and all the safety
standards described herein.

Although safety devices are installed on the appliance, avoid touching the moving parts with your
hands and avoid touching the appliance with wet hands.

Before cleaning or servicing the appliance, disconnect from the power supply.

When cleaning or servicing the HM-12/HM-22/HM-22B (safety protections removed) take into
consideration all possible hazards-Residual Risks.

When cleaning or servicing the appliance always concentrate on what you are doing and avoid
any possible distractions.

WARNING - The machine should only be repaired by a qualified technician.

If the power supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons.

Check the electricity power cable on a regular basis; to avoid electrical hazards and twists in the
cable always completely unwind it; a worn or damaged cable causes a dangerous electrical
hazard; avoid pressing the cable with weights or leaving it on hearted or sharp cutting surfaces
and avoid pulling the cable to remove the plug from the socket.

If the HM-12/HM-22/HM-22B has a presumed malfunction or does not work correctly, do not use it
or repair it. Contact the agent or a qualified technician.

This appliance is designed for only mincing meat. Do not use this appliance for
frozen food or non-food products and do not insert any metallic objects into the grinder.

Do not mince without using the pestle
The manufacturer cannot be held responsible for the following situations:

If the appliance or safety devices are tampered with by unauthorized personnel;

If non-original spare parts are used;

If the instructions given in this manual are not carefully followed or respected;

If unsuitable cleaning products (inflammable, corrosive or toxic) are used to clean the appliance.
1.2 SAFETY FEATURES INSTALLED
Safety features against electrical hazards conform to standards IEC/EN60335-2-64, whereas
mechanical safety features conform to EN/IEC60335-2-64 .
The HM-12/HM-22/HM-22B supplied with:
Relay in the command circuit for restarting the appliance if there if there is a power cut;
The HM-12/HM-22/HM-22B is supplied with electrical and mechanical safety protections that conform to
the standards in force .These protections are for when the appliance is operating and when it is being
cleaned or serviced .However there are RESIDUAL RISKS that cannot be completely eliminated and
are indicated by the wording CAUTION in this manual. These risks refer to the risk of being cut or
injured when handling the blade on the HM-12/HM-22/HM-22B while cleaning.
1.3 APPLIANCE DESCRIPTION
1.3.1 GENERAL DESCRIPTION

We have designed and manufactured the HM-12/HM-22/HM-22B guaranteeing:

Maximum safety when using, cleaning and servicing;

1 INFORMATION ABOUT THE APPLIANCE