Mounting Safety Shield Assembly; Mounting Work Rest; Mounting Grinder To Workbench - PowerTec 11801 Owner's Manual

MOUNTING SAFETY SHIELD ASSEMBLY

Refer to Figure 2
• Fasten the Safety Shield Assemblies to the Safety
Shield Brackets using the Safety Shield knobs and the
5mm washers. NOTE: The slotted part of the safety
shield bracket must face towards the grinding wheel
guard.
• Attach the Safety Shield Assembly and bracket to the
wheel guard using a washer, lock washer and rear
shield bracket knob.
4
Figure 2
Small Washer
Small Knob
Washer
Lock Washer
Rear Shield
Bracket Knob

MOUNTING WORK REST

Refer to Figure 3
• Remove the knob, star washer, and washer from the
carriage bolt on the lower portion of wheel guard.
• Using the slotted screw, lock washer, washer and
fastening knob, attach the work rest bracket to the
inside of the wheel guard as shown.
NOTE: The grooved work rest mounts on the left side.
NOTE: The work rest bracket's lower slot must be
positioned over the pin on the guard.
• With the remaining fastening knob, install the work rest
to the bracket.
NOTE: Adjust the distance between the wheel and the
work rest to maintain 1/16 in. or less separation as the
diameter of the wheel decreases with use.
Shield Bracket
(Right)
Safety Shield
(Right)
Figure 3
Knob

MOUNTING GRINDER TO WORKBENCH

Refer to Figure 4
WARNING
Always make sure your bench grinder is securely mounted
to a workbench. Failure to do so could result in an acci-
dent resulting in possible serious personal injury.
• Use 1/4 in. bolts, washers, and nuts (not included). The
bolt length should be 1-1/2 in. plus the thickness of the
workbench.
• Locate and mark the holes where the grinder is to be
mounted.
• Drill four 3/8 in. diameter holes through workbench.
• Place sander on workbench, aligning holes in base with
holes drilled in workbench.
• Insert four 1/4 in. diameter bolts and washers and attach
nuts securely.
Figure 4
Hex Bolt
Washer
Washer
Lock Washer
Hex Nut
Work Rest
Assembly
Washer
Star Washer