NHBoard TGN Series Installation And User Manual page 10

Installation and User G uide of Board
wall mounting procedure
1. Fetch the interactive whiteboard
from the package
2. Unscrew the four sets of inner
hex head screws and its cushions
from quadrate tube bracket
3. Unscrew the four sets of bolts
and its nuts of the L-shaped
metal bracket
4. To mount the quadrate tube
bracket on the TGN series
interactive whiteboard by
screwing the above mentioned
inner hex head screws M6×16.
5. Set up the two Expansion Bolts
and make sure 1190mm
distance remain between these
two L-shaped metal brackets,
1775mm height distance from
floor to the top-fixed Expansion
Bolt, marked the right positions
with pencil.
6. Drill 70mm hole on the wall with
percussion drill 12mm, and
position the Expansion Bolt into
the hole, strengthen and fasten
them.
7. Unscrew nuts of the above
Expansion Bolts, temporarily
hang the two L-shaped metal
brackets on them, screw and
fasten the nuts.
8. The illustration on the right
shows the common heights of
300mm for adjusting when you
finished steps 3 and attach the
back of Interactive Whiteboard
upon the L-shaped metal
brackets
9.
10
Ideas of Interaction