Table of Contents
Advertisement
44
Installation
When discharging into a standpipe
ensure that the top of the standpipe is
no more than 90 cm (35.4'') and no less
pi
than 60 cm (23.6'') above floor level.
The drain hose may be extended to a
maximum of 4 metres. An additional
drain hose and joining piece is available
from your local Service Force Centre.
The joining piece must have an internal
diameter of 18 mm.
If your drain hose looks like this (see the relevant
pcture) you do not require the "U" piece". Just push
the hose firmly into the standpipe.
2. Onto a sink outlet spigot.
If the outlet spigot has not been used before, remove any blanking plug that may
be in place.
Push the drain hose onto the spigot and secure with a
clip if required, ensure a loop is formed in the drain
hose (see diagram) to prevent waste from the sink
entering the washing machine.
The drain hose may be extended to a maximum of 4
metres. An additional drain hose and joining piece is
available from your local Service Force Centre. The
joining piece must have an internal diameter of 18
mm.
If you intend the drain hose from the machine to
empty into a sink, make sure that the sink is empty and
the plug hole is not blocked. Use the plastic "U -Piece"
supplied.
Hide quick links:
Advertisement
Table of Contents
