Route; Sail Plan - Nexus NX2 Installation And Operation Manual

6.4

ROUTE

Note! This page is only accessible when the NX2 GPS
Navigator is in MASTER or SLAVE mode. Not accessible when
operating as a REPEATER. See 7.7.
Access levels and summary of the ROUTE functions
"FIRST SHOWN"
"Press DOWN"
"Press DOWN"
"Press DOWN"
"Press DOWN"
6.4.1

SAIL PLAN

The SAIL PLAN
is
insert one or more WP's to form a number of LEG's. The
complete SAIL PLAN can then be stored and named in ROUTE
STORE. Up to 24 WP's can be used in plan ( Each ROUTE can
then consist of maximum function each sail 24 WP's).
NOTE! A route is a stored Sail Plan. The Sail Plan is the current list of waypoint to go to and when
you pass a waypoint, it will disappear from the Sail Plan list. (However, the waypoint is still in
memory)
How
to make the first LEG:
Press SET in SAIL PLAN
WP 000 is defined as present "START" position. NXT (Next)
indicates that the next WP is ready to be selected to form the first
LEG.
Note! You may choose any other waypoint as the "START" WP.
Press the MINUS button.
To select another FROM WP, press the SET and select your start
WP. The primary effect is that the X-track error will be calculated by
use of the new FROM WP and the TARGET WP, see drawing
SAIL PLAN (Create, or edit the sail plan),
chapter 6.4.1
ROUTE CALL (Call a route for use),
chapter 6.4.2
REVERSE CALL (Call a route for use in
the opposite direction), chapter 6.4.3.
DELETE (Delete a route), chapter 6.4.4.
ROUTE STORE (Store the complete sail
plan as a route), chapter 6.4.5.
the "tool" where you can create, delete
32
GPS NAVIGATOR
or