Definitive Technology ProSub 800 Owner's Manual page 9

current going to it, it will reactivate itself with a pop when AC current is
restored, which is normal.
Please note that after the cessation of a signal, it may take up to an hour
for the amplifier to actually tum off from active to staildby mode. In some
instances, because of RF presence in your area, the red LEDs may not tum
off. However, this is nothing to be concerned about as the amplifiers draw
almost no power when they are idling.
Using the ProSub with Definitive ProMonitors
When using the ProSub with Definitive ProMonitors, please consult
your ProMonitor instruction manual for specific information regarding
hookup, wiring and placement.
Setting the Level and Crossover Frequency When Using
the ProSub with ProMonitors .
When you have the ProMonitors wired to the speaker level outputs
on your ProSub, the following are our suggestions for starting settings on
your controls. Remember, these
ar~
just approximate settings and we suggest
experimenting to determine the best-sounding settings for your particular
set-up.
1. Set the variable low pass crossover control on
the back of the ProSub to approximately 2
0'
clock. Please note that the exact frequency
will depend on many factors including specific
positions of the speakers in the room, so you
might experiment with a slightly higher or
lower setting to achieve ideal blending
between the sub and the satellites for your
particular set-up. Listen to a wide variety of
music to determine the correct setting for this
in your system.
2. Set the subwoofer level control to 12
0'
clock.
Please note that the exact level depends on
many factors including your room size,
position of the speakers, etc. as well as
your personal listening taste, so you might
experiment with the subwoofer level while
listening to a wide variety of music until you
achieve the ideal setting for your system.
•