Sound Tips............... Settings and Sounds............Installation and Maintenance........Front Panel Controls............. Rear Panel Controls............1001RB-II/700RB-II Series Combos......Tech Talk............... Specifications..............*All Features and specifications are subject to change without notice **This list is subject to change without notice. Please read the Safety Information section on page 5 before continuing.
Gallien-Krueger are pleased that you chose us, and are determined that you will be a satisfied customer. us as soon as possible at:...
Page 4
Having taken our own path, G K products enjoy a unique, unmatched sound, allowing the artist using them every opportunity to make an original statement. Having supported my products for over thirty years, I have learned from the story they tell. Gallien-Krueger Gallien-Krueger Gallien-Krueger Gallien-Krueger Gallien-Krueger is a reflection of that story, and has a commitment to support that legacy.
To avoid safety hazards, use only the power cord supplied with your unit. If a replacement cord is used, make Your new 1001RB-II/700RB-II Series Bass Amp has certain that it is of consistent quality and gauge as the been factory configured for use with: original.
700RB-II/1001RB-II Series Quick Start The 1001RB-II/700RB-II is designed to be simple to operate. All controls have a well defined purpose and are well behaved. These directions will take you through the basics and give you a good start for setting up your sound.
Operation: series cabinet (with switch on the cabinet set to Bi- The 1001RB-II/700RB-II series amplifier is config- Amp) to the 1001RB-II/700RB-II with the supplied 4 ured for normal operation when you are connect- conductor Speakon cable. This setup gives the...
1001RB-II/700RB-II Series does just that. only effected by the Level, -14dB Pad, and Tuning When it is out, the 1001RB-II/700RB-II is voiced like Mute controls. This allows you to adjust your tone the 800RB. Push it in and the 1001RB-II/700RB-II is and volume on stage without changing the Direct voiced for five string instruments.
700RB-II/1001RB-II Series Settings and Sounds: 1001RB-II & 700RB-II The 1001RB-II/700RB-II is versatile in its sound and tone. Below are a few suggested amp settings that can be used as starting points to define your own sound. * C o n t o u r n o t e :...
Avoid spraying support the amplifier’s weight. To save space insecticides near the unit. in your rack, the 1001RB-II/700RB-II’s feet can be removed using a Philips head screw Maintenance: driver.
700RB-II/1001RB-II Series Front Panel Controls 1-Balanced Direct Out: 9-High Mid: An electronically balanced output, that you can run to your P.A. system. Boost and cut at 1 kHz +6dB/ -10dB, “Q Optimized,” band pass type. Works 2-Ground/Lift: on lower string harmonics, and effects the punch of your sound.
Normal Operation on page 7 for more information. Caution: Do not connect a Speakon cable labeled “Bridge Mode” to the 1001RB-II/700RB-II. This may result in damage to the amplifier. Maximum Recommended Load: One 4 Ohm or two 8 Ohm cabinets on the Woofer/ Main Amp.
The 1001RB-II/700RB-II combo electronics are To disengage the Lock N’ Roll system, first return the identical to the 1001RB-II/700RB-II head and are combo to its upright position and stand behind the rated for the same maximum power output and unit.
Bi-Amp sound. This is the reason the · Four, Bass specific bands of active 1001RB-II/700RB-II Series is a Bi-Amp, and it is the equalization for precise tone control. reason you will be able to explore an entirely new ·...
Page 15
1001RB-II/700RB-II Series does just that. connections. Be sure that you are not exceeding the When it is out, the 1001RB-II/700RB-II is voiced like maximum recommend load described in this manual. the 800RB. Push it in and the 1001RB-II/700RB-II is If the problem persists, contact GK directly for techni- voiced for five string instruments.