Toro Power Clear 38585 Operator's Manual page 17

Figure 39
1. Cable clamps
2. Position the Quick Shoot control between the two
arrows located on the right hand side of the upper
handle (Figure 40).
Figure 40
1. Arrows
3. Rotate the discharge chute so that it faces straight
ahead and the arrow on the back of the discharge
chute aligns with the arrow on the shroud (Figure 41).
4. Hold the discharge chute in the straight-ahead
position, pull the lower cable casing downward until
you remove the slack in the cable, and tighten the
screw on the lower cable clamp securely (Figure 42).
1. Lower cable casing
5. Pull the upper cable casing forward until you remove
the slack in the cable, and tighten the screw on the
upper cable clamp securely (Figure 43).
17
Figure 41
Figure 42