Dremel 1671 Owner's Manual page 12

Maintenance Informatio
FOR YOUR OWN SAFETY. TUR N
AWARNING
SWITCH "OFF'. AND REMOVE PLUG
FROM POWER SOU RCE BEFORE LUBR ICATING OR
DOING ANY MAINTENANCE ON YOUR SAW.
GENERAL
An occasional coa of paste wa on the w ork tab le will
allow the wood being
CUt 0
glide smoothly across the
work surface.
ARM BEARINGS
Lubricate the arm Dear gs I a er 10 hou rs of
use. Re-oil after eve 50 ours of use enever th ere
is a squeak corning ro the bearings
TO LUBRI CATE
1. Turn sa n Its side as shown
In
F 2).
2 SquIrt a generous amount of S around the
shaft end and bronze bearing .
3 let the oil soak in over igh t
In
4. Next day repeat the above proced
sIde of the saw.
CAUT ION:
Any servicing of this tool shaul
armed by an
authOrized service representativ
••(.C]
If \\
UNITED STATES
Dremel SeNlee Centers, 491 5 Twenty-first St.. Racine, WI
53406, or 463 E. Sunny Dunes Palm Springs. CA 92264.
CANADA
Giles Tool Agency 6520 Lawrence avo east Scarborough,
Ont. Canada C 4A 7, or Totem Tools 3851 Main st. Van­
couver B.C. Canada V5V 3P1 .
IM PORTANT! Use of an a
es or attach ments other than those
Su
piled by Dremel may be hazardous.
rom power source
TROUBLE
PROBABLE CAUSE AEMEDY SUGGESTED
AWARNING
ooting
BREAKING BLADES
MOTOR WILL NOT RU
1. W rong tension .
2. Over work ing blade.
3. Wrong blade applicati on.
4 . Twisting blade in w ood.
~ .
Incorrect teeth per inch .
Defective cord or pl ug.
2 . Defective motor.
3. Defective wire connections.
sawagam
2. Consul' Dremel Service. Any a tempt to
& repair
thiS
'TIotor may create a HAZARD
3. unless repa r
IS
done by a qualified
service technICIan
VIBRATION
NOTE: There will always
be some vibrat ion present
when the saw is running
because of m otor
operation.
1. Impr per lTlou nting of saw.
2 . Unsuitable mounting
smface.
3. Loose table or table
resting against motor.
4. Loose motor mounting.
1. See mounting instructions in this manual
for proper mountIng techn ique.
2. The
~eavler
your work bench is, the less
vibratIon will occur. A plywood workbench
will not be as good a work surface as the
same size solid lumber. Use common
sense in choosing a mounting surface.
3. Tighten table lock knob.
4.
Tighten mounting screws.
BLADE RUNOUT-Blade not 1. Blade holders not aligned. 1. Loosen cap screws holding blade to arms.
in-l i'ne w ith arm motion Adjust blade holders poSItions-ret ighten
screws. (3.5mm allen wrench required) .