Installation - AEG Voxtel R300 User Manual

3

INSTALLATION

3.1 Removing the belt clip
Pull the belt clip latch forward
(away from the PMR).
While pulling the belt clip latch,
push up the belt clip as shown in
Fig. 1.
3.2 Installing the belt clip
Slide the belt clip into the slot as
shown in Fig. 2.
>A "click" indicates the belt clip
is locked into its position.
3.3 Installing the batteries (see P3)
Caution:
Observe the proper battery polarity orientation when installing
batteries. Incorrect positioning can damage both the batteries and
the unit.
Slide down the battery compartment cover.
Insert the rechargeable batteries following the orientation as shown
in P3.
Replace the battery compartment cover.
Important:
Read these safety warnings before you charge the batteries.
When placing the PMR in the charger, use only the power supplies
listed in the user instructions supplied with the devices
Don't try to recharge non-rechargeable batteries.
Make sure the battery compartment cover is securely locked in place
when you are charging the batteries.
Dispose of used batteries safely and in a way that will not harm the
environment, never try to burn them or put them anywhere, they
could get burnt or punctured.
Don't leave dead batteries in your PMR units. They might leak if you
do and damage the PMR.
Belt clip latch
Fig. 1
5
Fig. 2