Table of Contents
Advertisement
Beginning Assembly
This section covers the basic assembly and adjust-
ment instructions needed to begin operation.
Complete the assembly in the order provided in this
manual and then read the remaining portion of the
manual before attempting any type of operation.
Your safety is important! Please follow the
warnings below during this entire section:
Sharp edges on metal
parts may cause person-
al injury. Examine the
edges of all metal parts
before handling.
!
Mount Scroll Saw
To attach the scroll saw to a solid surface:
Locate a rectangular piece of
1.
that is at least 20"W x 16"D.
Mount the base of the scroll saw to the cen-
2.
ter of the plywood with
1
⁄
" washers.
4
Clamp the plywood securely to a workbench.
3.
To permanently mount the scroll saw to the
4.
workbench, screw
with
1
⁄
" washers directly to the workbench.
4
-12-
Disconnect power to
the machine during the
entire
assembly
process. Failure to do
this may result in seri-
ous personal injury.
3
⁄
" plywood
4
1
⁄
" x 1" lag bolts and
4
1
⁄
" x 1" (or longer) lag bolts
4
Attach Blade Guard
To attach the blade guard:
1.
Set the blade guard on the scroll saw table
and position it around the upper arm.
Thread the bolt through the blade guard
2.
components as shown in Figure 4, and
screw it into the knurled nut.
Figure 4. Blade guard assembly.
Adjust the dust blower mounting plate and
3.
the blade guard so that they ride just above
the workpiece, and tighten the knurled nut
shown in Figure 5.
Figure 5. Blade guard adjustment.
Knurled Nut
G0536 Scroll Saw
Advertisement
Table of Contents
