Grizzly H3390 Instruction Manual page 14

9. Attach the blade guard to the motor assem-
bly using the M8-1.25 x 30 lock knob and M8
flat washer as shown in Figure 11 . Tile saw
blades are sold separately.
Blade Guard
Figure 11. Attaching the blade guard.
10. Place the water pump inside the water reser-
voir and plug the pump cord into the recepta-
cle on the side of the motor assembly. A plas-
tic hose runs from the pump to a "Y" connec-
tor and then slides through two mounting
holes on each side of the blade guard base
( Figure 12).
Hose
Mounting
Holes
Figure 12. Lube system.
-12-
Lock Knob
"Y" Connector
Water Pump
11. Slide the chrome table rail through the
mounting holes on the table as shown in
Figure 13 .
Saw Table
Table Rail
Figure 13. Assembling the table rail.
12. Slide the silver aluminum rail cover over the
rail as shown in Figure 14 .
Rail Cover
Figure 14. Assembling the rail cover.
H3390 Wet Tile Saw