Advertisement
4
Close and seal battery compartment as shown.
Make sure O-ring is perfectly clean.
8
III. Trouble Shooting Guide
1
Flash does not fire when switch is turned from "ON" to "TEST".
a
Wait until the orange flash-ready light is on. If it does not turn on, check that
batteries are inserted correctly.
b
Test or replace batteries.
c
If a and b above do not correct the problem, send to SeaLife Service Center:
(856) 866-9192 or service@sealife-cameras.com
2
Flash fires as tested above, but does not fire when triggered by camera.
a
Turn camera power on and wait until green flash-ready light in camera
comes on, and orange flash-ready light of flash is on.
b
If camera-ready light does not come on, check camera batteries and instructions.
c
If built-in camera flash does not fire, despite correctly inserted, fresh
batteries (also test the camera without housing in a dark place), send
complete camera, housing and flash to SeaLife Service Center.
d
If built-in camera flash does fire, but external flash does not work, check if
switch on flash is set to 'ON' and if orange light is on.
e
Check if there is a direct unobstructed path between the built-in camera flash and
the sensor at the bottom of the flash head. Adjust flash head position to make sure
the deflected light from the camera's flash hits the sensor at the bottom of the flash
head. There should be no obstruction in this path (like your hand or glove).
17
Advertisement
