Installing The Firmware Update On The Mate3 - OutBack Power MATE3 Owner's Manual

Programming

Installing the Firmware Update on the MATE3

To install the Firmware Update to the MATE3:
1. Power up the MATE3 by connecting the CAT5
cable from the system to the MATE3.
2. Insert the SD memory card according to
F igure 157.
4
3. Access the Main Menu
Main Menu
4. From the
Firmware Update
5. From the Firmware Update
MATE3
.
MATE3 Firmware Update
6. From the
press the key labeled
7. The screen will show
Processor
. The yellow battery LED will flash
rapidly.
Once the update is complete, the MATE3 will
automatically reboot itself and return to the
Home screen.
The firmware update is complete.
NOTE: Updating the firmware will not
reset the MATE3 to factory defaults.
136
as shown on page 7 1.
4
screen, select
.
screen, select
screen,
Update .
Updating Main
Figure 164 Installing the Firmware Update
SD Card Icon
900-0117-01-00 Rev B