Pico Macom CA-30 Installation And Operation Manual

Pico Macom CA-30 Installation And Operation Manual

550mhz push-pull distribution amplifier
Hide thumbs Also See for CA-30:

Advertisement

Quick Links

CA-30/550
550MHz Push-Pull Distribution Amplifier
Installation and

Operation Manual

Operation
www.picodigital.com
Ph:800-421-6511
Manual
Rev. 02/13

Advertisement

Table of Contents
loading

Summary of Contents for Pico Macom CA-30

  • Page 1: Operation Manual

    CA-30/550 550MHz Push-Pull Distribution Amplifier Installation and Operation Manual Operation www.picodigital.com Ph:800-421-6511 Manual Rev. 02/13...
  • Page 2: Important Safety Instructions

    To insure proper installation and operation, take a moment to read this guide before proceeding with the installation. If you have any questions or comments about the CA-30/550 Push-Pull Distribution Amplifier, please contact your dealer or have him contact the PICO MACOM Service Center at the phone numbers at the bottom of the page.
  • Page 3 Safeguards CA-30/550 11. Power Sources: This product should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supplied to your home, consult your appliance dealer or local power company.
  • Page 4 MDU, CATV, and SMATV systems. Because of its extremely low-noise figure ability and corrosion resistance and low distortion, the CA-30/550 is ideally suited for use in larger networks Also available in a rack mount where amplifier cascading is required. In expanding bi-directional broadband version as CA-30RK550 (30dB) systems, Pico Macom’s PIDA series bi-directional amplifiers should be...
  • Page 5: Specifications

    Noise Figure: 5.0 dB 2.3 lbs. Second Order Beats: -70 dB Composite Triple Beat: -61 dB Channel Loading Specifications Total # of Channels Input Level Output Level (dBmV) (dBmV) Ordering Information CA-30/550 - 550MHz Push-Pull Distribution Amplifier www.picodigital.com Ph:800-421-6511 Rev. 02/13...
  • Page 6: Operations And Controls

    Operations and Controls CA-30/550 SPEC GAIN TILT CA30/550 -20dB 550MHz Push-Pull Distribution Amplifier OUTPUT TEST 54-550MHz -20dB 30dB GAIN INPUT TEST POWER IN AC 117V Front Panel Controls and Specifications Gain: Adjust potentiometer for overall amplifier gain level. Tilt: Adjust potentiometer provides for slope adjustment over entire bandwidth.
  • Page 7: Installation Procedure

    OPERATING GUIDELINES Below is a chart showing the proper operation level for the CA-30/550. Please note the listed performance crite- ria is for SPECIFIC numbers of channels, and must be de-rated accordingly when inserting additional channels.
  • Page 8: Warranty Limitations

    Pico Macom warrants to the original purchaser a full 1-year warranty period common carriers’ requirements. Please make note of any obvious damage on all new products. Pico Macom will repair or, at its discretion, replace or shortage on the freight bill or carrier’s receipt next to your signature. The without cost to the original purchaser, the product which, upon inspection carrier’s agent must also sign acknowledging the loss.

This manual is also suitable for:

Ca-550Ca-30/550

Table of Contents