Operating Instructions; Stand-Alone Mode (Sound-Active, Auto Mode); Dmx Mode - Chauvet Scorpion Storm RG User Manual

5. O
PERATING

Stand-Alone Mode (Sound-Active, Auto Mode):

This mode allows a single unit to run to the beat of the music, or the unit will auto change in Auto
Mode. When all dipswitches are in the Off position, the unit will run in sound active mode.
You may use a combination of the dipswitches to create your desired effect.
1) Set dipswitches position, as desired, using the below values.
Dipswitches
1
2
3
4
5
4+5
6
7
6+7
8
9
8+9
10
2) The unit will react to the low frequencies of music via the internal microphone in Sound Active
mode, or the unit will auto change in Auto Mode.
3) Use the audio sensitivity knob on the back of the unit to make the unit more or less sensitive in
Sound-Active mode. Turning the knob counterclockwise decreases the sensitivity; turning the
knob clockwise increases the sensitivity.

DMX Mode

This mode allows the unit to be controlled by any universal DMX controller. You must place the fixture
into DMX mode by turning the dipswitch #10 to the on position. If you are unfamiliar with DMX, please
read the DMX Primer on page 18.
-The example listed below demonstrates a fixture set to DMX mode at DMX address 001.
DMX Mode
Switch # 10
Switch # 1
Scorpion™ Storm RG User Manual
I
NSTRUCTIONS
Note: the counter-clockwise rotation takes precedence over the clockwise rotation.
Function
= On
= On
13
On: Auto Off: Sound Active
On: Red (can be used in auto, rotation)
On: Green (can be used in auto, rotation)
On: right rotation; slow
On: right rotation; medium
4+5 On: right rotation fast
On: rotation in both directions; slow
On: rotation in both directions; medium
6+7 On: rotation in both directions; fast
On: strobe; slow
On: strobe; medium
both 8+9 On: strobe; fast
On: DMX operation/mode
1/26/2009 3:33 PM