Table of Contents
Advertisement
3. Enter in the [Name] that you want to use for this rule.
4. In the [Type] pull-down menu, select the data/traffic type that this rule will apply to.
The options are TCP | UDP.
5. Configure the [Port Number] that your application will be using as the outgoing trigger
ports.
6. Set the [Interval] of the rule. This is the time in between the outgoing and incoming
data traffic.
NOTE: If you set this value too low, the incoming ports will be closed before the return
data arrives at the firewall, the connection will be broken and the application will not
work.
7. The last 2 options are for Advanced Users, most users can leave these at the default
settings:
IR Replacement – Default Setting: Disable address replacement
Allow sessions initiated from/to the 3
8. When your configuration is complete, click the [Apply] button to save your changes and
return to the main Special Application page.
URL Blocking
This section allows you to control the content on the network. This feature is good for both
businesses and parents looking to control the content accessible from a web browser.
To access the URL Blocking configuration page, on the Side Navigation bar, click on [Firewall]
link and then click on the [URL Blocking] link.
To enable this option, click the [Enable Keyword Blocking] checkbox
Page 27 of 39
rd
host – Default Setting: unchecked
Advertisement
Table of Contents
