Table of Contents
Advertisement
21-1576_rsj_012604.fm Page 3 Monday, January 26, 2004 11:39 AM
2. At the marked positions, drill a hole slightly smaller than
the mounting screws. Do not drill into objects behind
the mounting surface.
3. Secure the mounting bracket to the mounting surface
with the supplied screws and lockwashers.
4. Attach the CB to the mounting bracket with the supplied
rubber washers and mounting knobs.
C
M
ONNECT THE
ICROPHONE
1. Align the holes inside the
microphone's plug with the
pins in the microphone jack
and insert the plug.
2. Turn the plug's locking nut
clockwise to secure it.
3. Slide the microphone onto
the holder.
4. To disconnect the
microphone, unscrew the
locking nut and pull the
microphone plug toward you. Do not pull the
microphone cable.
I
A
NSTALL AN
NTENNA
There are many different types of antennas for mobile CBs.
Dual band antennas provide optimum reception of CB and
WX channels. Your local RadioShack sells a wide variety of
antennas. When choosing an antenna, keep in mind that for
the best performance you should mount the antenna:
• as high as possible.
Mounting Bracket
Rubber
Washers
Mounting
Knobs
Microphone
Jack
Locking Nut
CAUTION
• To prevent damage to your CB,
do not attempt to transmit
without an antenna attached.
• Do not run the cable over sharp
edges or moving parts that
might damage it.
• Do not run the cable next to
power cables or other CB
antenna cables.
• Do not run the cable through a
vehicle's engine compartment
or other areas that produce
extreme heat.
3
Advertisement
Table of Contents
