Toshiba 5000 Series User Manual page 180

T Select tone dialing
This command instructs the modem to send DTMF tones while dialing.
Dialed digits are tone dialed until a P command or dial modifier is
received. This is the default setting.
Vn DCE response format
This command controls whether result codes (including call progress
and negotiation progress messages) are displayed as words or their
numeric equivalents.
V0
Displays result codes as digits.
V1
Displays result codes as text (default).
Result Codes:
n=0,1
OK
ERROR Otherwise
Xn Result code selection, call progress monitoring
This command selects which result codes will be used by the modem.
Command Dial tone
detect
X0 Disabled
X1 Disabled
X2 Enabled
X3 Disabled
X4 (default) Enabled
Busy signal Supported
detect Result Code
Disabled OK, CONNECT, RING, NO CARRIER,
ERROR
Disabled OK, RING, NO CARRIER, ERROR,
CONNECT <RATE>
Disabled OK, RING, NO CARRIER, ERROR,
NODIALTONE, CONNECT <RATE>
Enabled OK, RING, NO CARRIER, ERROR,
BUSY, CONNECT <RATE>,
BLACKLISTED
Enabled OK, RING, NO CARRIER, ERROR,
NODIALTONE, BUSY, CONNECT
<RATE>, DELAYED, BLACKLISTED,
REORDER, WARBLE, CALL WAITING
DETECTED
Appendix C
C-7